Re: Projecto Track Day by Valente (JÁ COM FOTOS)
Valente, tás a vontade, no que soubermos ajudamos, quantos mais em pista melhor.
Entretanto reuni os dados técnicos do teu bólide, pode ser que te ajude em alguma coisa.
Manufacturer: Daihatsu Model: Charade (79-93) 1,0
Engine code: CB-80 Output: 74 (100) 6500
No. of cylinders Type 3/OHC
Capacity (Fiscal) cc 993 (986)
Compression ratio :1 7,8
Suitable for unleaded petrol Yes
Minimum octane rating RON 91
Ignition system Type ESA
Ignition system Description Map-i
Trigger location Distributor
Fuel system Make Daihatsu
Fuel System Type EFI
Fuel System Description MFI-i
Air metering Type MAP
Combined ignition and fuel ECM Yes
Diagnostic socket Yes
Ignition system
Ignition coil Make Denso
Ignition coil supply voltage + with ballast V 12,0
Primary resistance Ohm 0,9-1,1
Secondary resistance Ohm 20700-25300
Firing order 1-2-3
Distributor (ECM) Make Denso
Tuning and emissions
1 Tuning conditions
Ignition timing - basic BTDC °Engine/rpm 10±2/950
Ignition advance checks °Engine/rpm ECM Controlled
Idle speed rpm 950±50
Oil temperature for CO test °C 60
CO level at idle speed - tailpipe Vol. % CO 1,0±0,5
HC level at idle speed ppm 300
CO2 level at idle speed Vol. % CO2 13-16
O2 level at idle speed Vol. % O2 0,5-2,0
Spark plugs
Spark plugs Original equipment Denso
Spark plug Type W20ETE-L
Electrode gap mm 0,9-1,0
Spark plugs Make Autolite
Spark plug Type 9063
Electrode gap mm 1,0
Spark plugs Make Bosch
Spark plug Type W7DTC
Electrode gap mm 0,8
Spark plugs Make Champion
Spark plug Type RC7YCC
Electrode gap mm 1,0
Spark plugs Make NGK
Spark plug Type BKR6EKN
Electrode gap mm 0,9
Service checks and adjustments
Notes Specified value Measured value
Valve clearance -INLET mm 0,27 hot
Valve clearance -EXHAUST mm 0,32 hot
Compression pressure bar 8,3-10,3
Oil pressure bar/rpm 4,4/2700
Radiator cap bar 0,74-1,03
Thermostat opens °C 88
Drive belt tension - alternator/PAS/AC mm 7,5-8,5
Lubricants and capacities
Notes Specified value Measured value
Engine oil grade - cold climate SAE 5W/30
Engine oil grade - moderate climate SAE 10W/40
Engine oil grade - hot climate SAE 20W/50
Engine oil classification API/ACEA SG/A2-96
Engine oil grade - alternative - moderate climate SAE 10W/30
Engine oil classification - alternative - moderate climate API/ACEA SG/A2-96
Engine with filter litres 3,1
Gearbox oil grade SAE 80W
Gearbox 4/5 speed litres 2,1
Cooling system litres 4,0
Brake fluid Type DOT 3
Power steering fluid Type Dexron II
Tightening torques
Cylinder head instructions
Cylinder head
Renew bolts No
Stage 1 Tighten 39-44 Nm
Stage 2 Tighten 59-69 Nm
Other tightening torques
Main bearings Renew bolts/nuts No
Main bearings Stage 1 30 Nm
Main bearings Stage 2 63-75 Nm
Big end bearings Renew bolts/nuts No
Big end bearings Stage 1 20 Nm
Big end bearings Stage 2 41-51 Nm
Oil pump to cylinder block 15-23 Nm
Sump bolts 4-7 Nm
Flywheel/driveplate 59-69 Nm
Clutch to flywheel 15-22 Nm
Crankshaft pulley/damper 95 Nm
Camshaft sprocket/gear 30-45 Nm
Camshaft/rocker cover 8-12 Nm
Inlet manifold to cylinder head 10-16 Nm
Exhaust manifold to cylinder head 10-16 Nm
Spark plugs 15-22 Nm
Steering track rod end 30-45 Nm
Brake disc to hub Front 39-54 Nm
Brake caliper carrier to hub Front 37 Nm
Brake caliper to carrier Rear 27 Nm
Brake caliper carrier to hub Rear 45 Nm
Starting and charging
Battery V/RC(Ah) 12/65 (36)
Starter motor Make Denso
Starter motor Type 1,0kW
Maximum cranking amps A 97-119
Alternator/Regulator Make Nippon Denso
Alternator output at engine speed A/V/rpm 53/13,5/2500
Regulated voltage V 14,2-14,8
Brake disc and drum dimensions
Minimum disc thickness - solid Front 10 mm
Minimum disc thickness - ventilated Front 17 mm
Minimum disc thickness Rear 8 mm
Maximum drum diameter Rear 182 mm
Minimum pad thickness Front 1 mm
Minimum shoe thickness Rear 1 mm